2 Comments

1. V2000-c Rfid Access Control User Manual [new] May 2026

   The V2000-C RFID Access Control is a standalone 125KHz EM card system supporting up to 1,000 users, offering adjustable door open times, and featuring a rugged plastic, non-waterproof design. While praised for its fast response time and versatility, users often report complex programming procedures. For official setup instructions, you can download the V2000-C User Manual directly from Obohands. programming NTIL V2000-c+ RFID Access Keypad - JustAnswer

   4.3 Deleting Users

   • Single Delete: 14 [User ID] #
   • Delete All Cards (Keep Master Code): 14000000 # (Use with extreme caution).

   What’s in the Box

   • V2000-C RFID reader/controller
   • Mounting screws and anchors
   • Quick start guide
   • Warranty card

   • Why this matters: Leaving the default code unchanged is a major security vulnerability. Anyone with access to the keypad could theoretically reprogram your locks. The manual provides the specific keystrokes required to set a unique admin code, ensuring that only authorized personnel can add or remove users.

   Part 1: Unboxing & Initial Hardware Overview

   Before interfacing with the keypad or software, you must understand the physical components of the V2000-c. V2000-c Rfid Access Control User Manual

   1. Setting Up Access Levels: Configure access levels to restrict access to specific areas or premises.
   2. Enrolling Users: Enroll users by assigning RFID cards or tags to authorized individuals.
   3. Setting Up Time Zones: Configure time zones and holidays to restrict access during specific times.
   4. Configuring Event Log: Configure the event log to track access attempts.

   • This could have to do with the pathing policy as well. The default SATP rule is likely going to be using MRU (most recently used) pathing policy for new devices, which only uses one of the available paths. Ideally they would be using Round Robin, which has an IOPs limit setting. That setting is 1000 by default I believe (would need to double check that), meaning that it sends 1000 IOPs down path 1, then 1000 IOPs down path 2, etc. That’s why the pathing policy could be at play.

     To your question, having one path down is causing this logging to occur. Yes, it’s total possible if that path that went down is using MRU or RR with an IOPs limit of 1000, that when it goes down you’ll hit that 16 second HB timeout before nmp switches over to the next path.