Exclusive - Ts1162 Installation Manual

Exclusive Installation Guide for the Tecom TS1162 3-LED RAS Keypad

, the general physical installation steps for this series of RAS keypads include: support.firesecurityproducts.com.au The unit can be mounted indoors or outdoors. ts1162 installation manual exclusive

• Locate the ON Tripper (usually color-coded or labeled) and the OFF Tripper.
• Loosen the screws on the trippers or snap them out (depending on the specific tripper style).
• Move the ON Tripper to the time on the dial you want the device to turn on.
• Move the OFF Tripper to the time you want the device to turn off.
• Tighten the screws securely so they do not slip.

The Three-Cable Rule

You must use three separate earth paths: Exclusive Installation Guide for the Tecom TS1162 3-LED

Environment: Ensure the installation area is clean, dry, and has at least 12 inches of clearance for ventilation. 2. Physical Mounting and Positioning Locate the ON Tripper (usually color-coded or labeled)

• Verify device model and voltage.
• Mount and secure device.
• Connect ground and power.
• Wire inputs, outputs, and comms.
• Set network and device parameters.
• Change default passwords.
• Update firmware if available.
• Test each circuit and document results.