Ts1162 Installation Manual _hot_ Link

The Tecom TS1162 is a 3-LED Remote Arming Station (RAS) keypad designed for use with Challenger security systems. It features a robust IP67-rated housing, making it suitable for both indoor and outdoor installation in dusty or wet environments. Installation Guide for Tecom TS1162 1. Preparation and Safety

2.2 Panel Mount (Flush)

Set LAN termination (DIP switch 8) if the device is at the end of a LAN run. Final Assembly ts1162 installation manual

10. Common Error Codes

| Code | Meaning | Fix | |------|---------|-----| | E01 | Temp probe short | Replace probe | | E02 | RH sensor stuck | Desiccate for 24 hrs | | E07 | CO2 reading >3000 ppm | Vent room, re-zero | | E14 | Relay 1 welded | Replace relay board | | E99 | Firmware corruption | USB reflash (see Appendix C) | The Tecom TS1162 is a 3-LED Remote Arming

Example Review Based on Hypothetical Use

Product/Service: Assuming TS1162 is a piece of technical equipment, possibly related to telecommunications or electronics. Cutout dimensions: Per the TS1162 installation manual –

5.2 Load Outputs (Relays 1–6)

| Relay | Label | Recommended Load | |-------|-------|------------------| | 1 | HEATER | Max 1500W resistive | | 2 | COOLER | Compressor delay enabled (3 min) | | 3 | HUMIDIFIER | Ultrasonic only (no steam) | | 4 | DEHUM | Drain line required | | 5 | CO2 REGULATOR | 24VAC valve max | | 5 | AUX LIGHT | 1000W LED or HID |

Error Codes: Consult the "Error Code Table" in the appendix of your physical manual for specific flashing patterns on the LED. Maintenance and Safety

  1. Application: (a) Grow Room (b) Wine Cellar (c) Custom
  2. Temperature Unit: °F / °C
  3. Day/Night Mode: Enable if using light sensor (included)
  4. Output Tuning: Select “PID Aggressive” for AC units, “Slow PID” for resistive heaters.
Top