Staples 17466 Laminator Manual
Staples 17466 9.5" Thermal and Cold Multi-Use Laminator is generally reviewed as
- Prepare the Pouch: Open the laminating pouch and place your document inside, centered between the two sides of the film. Leave a small border (approx. 3mm or 1/8 inch) around the edges of the document.
- Insertion: Insert the sealed edge of the pouch into the laminator first. This prevents wrinkles and jams.
- Feeding: Gently guide the pouch into the entry slot until the rollers grab it. Do not force it.
- Completion: The laminated document will exit from the rear of the machine. Allow it to cool flat for a few seconds to ensure the seal sets properly.
| After each use | Wipe exterior with damp cloth. | | --- | --- | | Weekly (if used often) | Run a cleaning sheet (or glossy paper) through to remove adhesive residue. | | Monthly | Check rollers for melted plastic; use warm, damp lint-free cloth on cool rollers. | staples 17466 laminator manual
into the machine. Align the pouch using the tray tabs to ensure it stays straight. Completion Staples 17466 9
Q: Do I need a carrier (folder)?
A: No. The 17466 is a direct-feed laminator. Carriers are only for older pouch-fed machines. Prepare the Pouch: Open the laminating pouch and
Step 3 – Warm-up
Wait 3–5 minutes until the red light turns GREEN. Do not feed any pouch while the light is red.