Skope Heated Towel Rail Timer Instructions -

Introduction

Programming on/off times:

  1. Press Mode until you see Prog (program).
  2. Use Up/Down to choose a program slot (e.g., P1, P2).
  3. Press Set → adjust ON hour/minutes → press Set.
  4. Adjust OFF hour/minutes → press Set.
  5. Choose which days to apply (e.g., weekdays, weekend, daily).
  6. Press Mode to return to auto mode.

5. Energy Saving Tip

Set your Skope timer to run only 2–4 hours before you shower/bathe and 1–2 hours after. Running all day costs roughly 10× more energy. skope heated towel rail timer instructions

  1. Searching: “Skope heated towel rail timer manual PDF”
  2. Checking the inside cover of your electrical meter box (electricians often leave manuals there).
  3. Emailing Skope support (they reply quickly with the exact model’s guide).

designed to provide warmth exactly when you need it without running the unit 24/7. 1. Manual Boost Mode Introduction Programming on/off times:

Set Current Time: Use the +/- keys to set the hour and minute, then press the menu button to confirm. Press Mode until you see Prog (program)

Quick setup (digital timer)

  1. Power on: switch on the rail at the wall isolator.
  2. Set current time: press the clock/time button, use up/down to set hours then minutes, confirm.
  3. Choose mode: short press “Mode” (or “Prog”) to enter schedule programming.
  4. Create on/off periods: select a program slot (P1, P2...), set ON time (hours:minutes), set OFF time, confirm. Repeat for additional periods (e.g., morning and evening).
  5. Activate schedule: switch from “Auto” or “Timer” mode to enable programmed periods; “On” keeps it always warm, “Off” disables heat.
  6. Adjust temperature: use thermostat knob or temperature buttons if available—timer only controls when the heater runs, not the set temp.
  7. Override: most units allow a temporary manual ON (boost) — press the manual/boost button to run for a set short period (e.g., 30–60 minutes) without changing the schedule.

Temperature Control: For most digital models, a setting of 23°C is the recommended maximum for efficiency.