Sepro Robot User Manual Hot - Hot!
Title: Navigating the Heat: Understanding Thermal Management in the Sepro Robot User Manual
- E-stop the robot and injection molding machine.
- Wait 20 minutes with cabinet door open. Use an external fan aimed at the servo drives.
- Reset thermal circuit – On Sepro S7/S8 controllers, locate the small red button on the Saftronics drive unit (lower right corner). Press firmly until it clicks.
- Clear alarm – On teach pendant:
Alarms > History > Clear All > Confirm - Perform dry cycle – Run the robot at 50% speed for 5 minutes. Monitor temperatures in diagnostic screen.
- If temperature rises faster than 1°C per minute, stop immediately – there is a mechanical binding issue.
Alternative: Check the back of your teach pendant. Many Sepro units have a quick-reference card taped inside the rear cover – including reset steps for HOT-01 through HOT-04 errors. sepro robot user manual hot
