Qidi X-pro Manual Instant

Introduction to the Qidi X-Pro

Filament Loading Text:

Filament Feeding Issues

If you hear a "clicking" sound:

Manual Mistake Alert: The original manual states the offset should be "around 32mm." In reality, due to manufacturing tolerances, your offset could be between 31.8mm and 32.4mm. Trust your measurement, not the manual's assumption. qidi x-pro manual

• Clean the Z-axis lead screws with a lint-free cloth.
• Apply a thin layer of Super Lube (21030) – Do not use WD-40.
• Clean the nozzle exterior with a brass brush.

The manual describes a three-point "assisted" leveling process. While not fully automatic, the printer guides the user through the steps via the touchscreen. Hardware Setup: Introduction to the Qidi X-Pro Filament Loading Text:

: The manual details an "assisted manual" leveling process where the printer moves to specific points, and the user must adjust the knobs until a piece of paper can just barely slide under the nozzles. The Dual-Nozzle Challenge : Because the X-Pro features a dual-head system Clean the Z-axis lead screws with a lint-free cloth