Jmm-al10 Test Point __hot__ -

Title: Unbricking the Huawei JMM-AL10: A Complete Guide to the Test Point and Factory Mode

⚠️ Important notes:

  1. Not all JMM-AL10 variants support the same test point — motherboard revisions vary.
  2. Shorting the wrong points can damage your device.
  3. You typically need:

    Method 1: For FRP Bypass (Using HCU or SigmaKey)

    1. Prepare the PC: Install the necessary drivers (Huawei USB drivers, MTK USB VCOM drivers). Disable driver signature verification on Windows.
    2. Open the software: Launch HCU (Huawei Crack Up) or SigmaKey software.
    3. Short the test points: Using tweezers, maintain contact between the two test point pads.
    4. Connect USB: While holding the short, plug the USB cable into the phone (and the PC).
    5. Release: After 2-3 seconds, release the short. The PC should make a "connected" sound.
    6. Check Device Manager: You should see a new port under "Ports (COM & LPT)" – either "MediaTek USB Port (COMx)" or "Huawei USB COM 1.0".
    7. Execute in software: In HCU, select the correct COM port and click "Read Info" or "Do Job" (Unlock/FRP Reset). The software will communicate with the phone via the test point-forced mode and remove the FRP lock.

    📍 Safety Warning: Opening your device voids the warranty and carries a risk of hardware damage. Proceed with caution. Step 1: Disassemble the Device jmm-al10 test point

Scroll to Top