Huawei Bg2-u01 Test Point 💯

Huawei MediaPad T3 7 3G (BG2-U01) , the hardware test point is used to force the device into a special interface mode for flashing or bypassing FRP (Factory Reset Protection)

Short the Pins: Use tweezers to hold the two test points together.

Typical Configuration: The test point usually requires you to short a specific point to the metal chassis (Ground) or to another adjacent point. huawei bg2-u01 test point

This article provides an authoritative, visual guide to locating and using the Huawei BG2-U01 test point to force the device into BROM Mode (Boot ROM) so you can flash stock firmware using SP Flash Tool or bypass the Google FRP lock.

(the metal shielding over the chips is the easiest ground) simultaneously. Connect to PC Huawei MediaPad T3 7 3G (BG2-U01) , the

Verify Connection: Look for a new entry in Device Manager under Ports (COM & LPT) titled SPRD U2S Diag or SPD VCOM.

To put the device into the required mode (often appearing as "Qualcomm HS-USB QDLoader 9008" or a Spreadtrum equivalent in Device Manager, depending on the specific chipset variant), follow these steps: Disassemble the Device Pad 1: Ground (Usually a larger exposed copper area)

• Pad 1: Ground (Usually a larger exposed copper area).
• Pad 2: KCOL0 (Forced Download).

Step 6: Prepare for Shorting

Connect a USB cable to your PC but DO NOT plug it into the phone yet. Open the SP Flash Tool and load your scatter file.