Galaxy - Aqua Premier Installation Manual !!link!!

Galaxy Aqua Premier is an instantaneous electric water heater (typically 9.5kW) designed for direct mains supply. Installation must be performed by a suitably qualified person and comply with (IEE wiring regulations). The Shower Doctor Core Installation Requirements Water Supply : Must be connected to the mains cold water supply Minimum Running Pressure

The Main Unit:

• The Manifold Head: The plastic housing where filters snap or screw in.
• Clear Sump Housings (Usually 3): For Sediment, Carbon, and Post-Carbon filters.
• RO Membrane Housing: Usually a long, cylindrical casing (often blue or white).

• Generally accurate for typical installs; however, it omits local code reminders (e.g., backflow prevention, electrical disconnect requirements) that vary by jurisdiction and should be called out for installers to verify.

• Electrical Safety: The Premier pump is often rated for submersible use but requires a GFCI (Ground Fault Circuit Interrupter) protected outlet. The manual explicitly warns against handling the pump with wet hands or when standing in water.
• Cable Integrity: Unlike standard appliances, the power cord on these pumps is sealed. The manual states that if the cord is damaged, the entire unit must be replaced (not repaired by the user).
• Dry Run Prevention: Running the pump without water causes seal failure within seconds. The manual specifies a maximum dry run time (usually 0 seconds) and describes the thermal overload shut-off feature.

: Recent reviews indicate that some original parts for the Galaxy Aqua Premier are being discontinued, leading installers to suggest alternatives like the Ariston Aures Slim for new setups. Professional Recommendations Qualified Personnel galaxy aqua premier installation manual

1. Locate the post-filter housing and remove it from the packaging.
2. Place the post-filter housing on a flat surface, with the inlet and outlet ports facing upwards.
3. Insert the post-filter into the post-filter housing, ensuring that it is securely seated.
4. Connect the permeate line from the RO membrane housing to the inlet port of the post-filter housing.
5. Connect the outlet port of the post-filter housing to the storage tank.

Positioning: Choose a flat vertical wall surface. Ensure the handset can reach the user but the shower head cannot be submerged in the bath or shower tray water (to prevent back-siphonage). Galaxy Aqua Premier is an instantaneous electric water

: The unit must be connected to a direct mains cold water supply. Operating Pressure : It requires a minimum running pressure of 100kPa (1 Bar) at a flow rate of at least 8 litres per minute The Manifold Head: The plastic housing where filters

4. Installing the Faucet (for Drinking Water Models)

• Drill a 1/2-inch hole in your sink top or counter (avoid granite without a professional bit).
• Insert the faucet base and rubber washer, then tighten the locknut.
• Connect the 1/4-inch blue tubing from the filter’s final stage to the faucet.