Firmware Reset Samsung Ml 2160 2165 2160w 2165w May 2026

A guide on firmware reset for Samsung ML-2160, ML-2165, ML-2160W, and ML-2165W printers. Here it is:

6) Troubleshooting

Reset combos not working: try different button-press counts and hold durations (5–15s).
Printer still shows “Toner Replace”: try service-mode toner counter reset; if print quality is poor, replace toner cartridge.
Network won’t connect: confirm SSID/password and 2.4 GHz vs 5 GHz (these models generally use 2.4 GHz). Ensure MAC filter or AP isolation not blocking device.
Firmware update fails repeatedly: try another PC, different USB cable/port, and reinstall drivers.
Printer unresponsive after failed firmware: avoid further attempts; contact service center.

Firmware Reset for Samsung ML-2160, ML-2165, ML-2160W, and ML-2165W firmware reset samsung ml 2160 2165 2160w 2165w

If the printer is responsive via USB or Wi-Fi: A guide on firmware reset for Samsung ML-2160,

You may need to perform a network reset separately:
Press and hold WPS button for 20 seconds until all LEDs flash → release.

Turn off the printer using the power button (or unplug it for 10 seconds).
Make sure the paper tray has paper and the rear door is closed.
Press and hold the Cancel button (red circle with ‘X’ / Stop button) and the Power button simultaneously.
Keep holding both for about 5–10 seconds.
Release only the Power button but keep holding Cancel.
Within 2 seconds, press the Power button again once while still holding Cancel.
Release all buttons.
The printer should start making noise – wait until all LEDs blink and then stop (about 15–20 seconds).
The printer will print a configuration page automatically. If it does not print, press the Cancel button once quickly.